Opening the lab

Principle of Moments  / CSEC Physics
sum of ACW = sum of CW
All labs
Add a load to begin
A seesaw beam pivoted at its centre. Loads placed on the beam create turning moments. PIVOT drag the loads along the beam

Add a load

Beam lengthpivot in the middle
Tap to place on the beam
Or put someone on it

Tap anything on the beam to change its mass or type its distance.

Try this: put Fatman Bob close to the pivot and Shania far out on the other side. A small force at a big distance turns just as hard.

Moment ledger

0 LOADS
No loads on the beam yet.
Add one from the panel to see its moment calculated.
Total anticlockwise
0.0N m
Total clockwise
0.0N m
Waiting for loads

What a moment actually is

A moment is the turning effect of a force about a pivot. Push a door near the hinge and it barely moves. Push at the handle and it swings easily. Same force, different turning effect.

Moment = F × d

Here d is the perpendicular distance from the pivot to the line of action of the force. Measured in newton metres (N m).

Which way the beam tips, and how far

Each load pulls straight down with its weight W = mg, and its turning effect about the pivot is the moment W × d, where d is the perpendicular distance from the pivot.

net moment = sum of CW − sum of ACW

The beam tips to the side with the bigger moment. The bigger the difference, the further it leans, until it reaches the stop (about 13 degrees). It stays exactly level only when the clockwise and anticlockwise moments are equal.

The beam is drawn leaning by an amount that grows with the net moment and then levels off, so a large difference always shows as the full lean. A small difference gives a small lean, which is how you can see how close you are to balance.

The Principle of Moments

When an object is in equilibrium:

sum of ACW = sum of CW

The total anticlockwise moment about any point equals the total clockwise moment about that same point. On the beam above, that is the moment the blue loads make against the moment the orange loads make.

For full equilibrium you also need the resultant force to be zero, which the fulcrum provides here.

Getting to the weight first

Loads are labelled by mass in kilograms, but a moment needs a force. Convert first:

W = mg

Taking g as 10 N/kg, a 2 kg load has a weight of 20 N. Only then can you multiply by the distance.

Common CSEC error: multiplying mass by distance and writing kg m. Moments are N m. Convert to weight first, every time.

Answering the exam question

  • Take moments about the pivot. That removes the unknown reaction force at the fulcrum, since its distance is zero.
  • Label each moment clockwise or anticlockwise before you calculate anything.
  • Write the principle as an equation before substituting. Method marks live there.
  • Use metres throughout. Centimetres are the most common slip.
  • Include units in your final answer. N m for moments, m for distances.

Where this shows up

  • Spanners and wrenches. A longer handle gives a bigger moment for the same effort.
  • Wheelbarrows and crowbars. Levers trading distance for force.
  • Cranes. Counterweights placed to balance the load being lifted.
  • Beam balances. The laboratory version of this seesaw.
  • Seesaws. A lighter person sitting further out balances a heavier one sitting closer in. Try Shania against Fatman Bob on the beam above.

Worked example

A uniform beam is pivoted at its centre. A 30 N weight sits 1.2 m to the left. Where must a 20 N weight be placed on the right to balance?

ACW = 30 × 1.2 = 36 N m
CW = 20 × d
For balance: 20d = 36
d = 1.8 m from the pivot

Set it up on the beam above and watch it level off.