Opening the lab
Whenever the magnetic flux through a coil changes, a voltage is induced across it. The faster the flux changes, the larger the voltage.
induced e.m.f. ∝ N × rate of change of fluxThe N is there because each turn of wire has the same voltage induced in it, and they add up in series.
| Do this | Voltage |
|---|---|
| Move the magnet faster | Increases |
| Use more turns | Increases |
| Use a stronger magnet | Increases |
| Hold it still | Zero |
All three of the first ones raise the rate of change of flux linkage, which is the single thing Faraday's law actually depends on.
The induced current always flows in the direction that opposes the change causing it.
So you are always working against the coil. That is not a nuisance, it is the conservation of energy: the work you do against the opposition becomes the electrical energy in the circuit.
Push the magnet all the way through and the meter swings one way, back through zero, then the other way.
Opposite changes, so opposite currents. And since the flux ends up exactly where it started, the two kicks cancel out overall.
With the magnet exactly at the middle of the coil, the flux is at its greatest. But the induced voltage is zero.
That is because Faraday's law depends on the rate of change of flux, not the amount of it. At the peak, the flux is momentarily not changing at all, so nothing is induced even though the magnet is moving quickly.
Watch the graph as you swipe through: the two humps are either side of the centre, and the trace crosses zero exactly as the magnet passes the middle.
Because the power depends on the voltage squared, doubling the voltage gives four times the power. That is why the lamp brightness changes so dramatically when you speed up the swipe.
A generator does the same job as your hand, but continuously. Instead of pushing a magnet in and out, it spins a coil in a field, or a magnet inside a coil.
The flux through the coil then rises and falls smoothly, over and over, giving a voltage that alternates in the same smooth way. That is where alternating current comes from.
The same three factors still apply: spin it faster, add more turns, or use stronger magnets, and the output rises.